crwdns2933803:01crwdne2933803:0
crwdns2933797:0Elizabeth Castillocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elizabeth Castillo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] WARNING: Always make sure that the device is unplugged and turned off. | |
| - | [* icon_caution] |
| + | [* icon_caution] Label each part taken out to track which piece goes where. |
| [* black] Unfasten the screws that hold the back cover on. | |
| [* icon_note] The screws which need to be removed are circled in the above image. | |
| [* icon_reminder] These should utilize a PH1 head and be approximately 1/2 threaded with an overall length of 4.15 millimeters. These screws should be held in place by a small plastic washer which secures them to the cover and should not be loose. This is illustrated in the third image. | |
| - | [* icon_reminder] Use a well labeled parts tray to contain any loose parts. |