crwdns2933803:04crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Reassembly information |
|---|---|
| + | [* icon_reminder] During reassembly, perform the following to replace the conductive tape: |
| + | [* black] Peel off the new conductive tape from its liner and apply the sticky end to the press connector, making sure to bridge the logic board. |
| + | [* black] Use a spudger, or your fingers, to press down the conductive tape and ensure a good seal. |
| + | [* black] Use tweezers, or your fingers, to pull on the tab and expose the tape. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0