crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Carefully re-clip the cord around the plastic pieces into its wedged position as shown.
- [* icon_caution] Be sure to apply enough pressure so it sits uniformly in the controller.
-[* black] Re-insert the shoulder triggers into their proper holes.
-[* icon_note] In this position, the L trigger will go on the right and the R trigger on the left.
-[* black] Screw the joystick assembly back into place.
+[* black] Carefully secure the cord around the cable clamps.
+ [* icon_caution] Be sure to apply enough pressure so it sits below or flush to the edge to avoid problems putting the front and back case together.
+[* black] Re-insert the shoulder triggers into place.
+ [* icon_note] The L trigger will go on the right and the R trigger on the left.
+[* black] Use a Phillips #0 screwdriver to secure the screws to the joystick assembly.