crwdns2933803:04crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the Touch ID sensor bracket |
|---|---|
| + | [* black] Use a T3 Torx screwdriver to remove the six screws securing the Touch ID sensor and its bracket: |
| + | [* red] Four 2 mm‑long screws |
| + | [* orange] Two 1.7 mm‑long screws |
| + | [* icon_reminder] During reassembly: |
| + | [* black] Install the screws without tightening them fully. |
| + | [* black] Open your MacBook and align the Touch ID sensor on the keyboard. |
| + | [* black] Close your MacBook and fully tighten the screws. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0