crwdns2933805:0crwdne2933805:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the remaining screws |
|---|---|
| + | [* black] Use one hand to steady both halves of the laptop so they don't separate and fall over. |
| + | [* red] With your other hand, use a T8 Torx screwdriver to remove the remaining 4.7 mm‑long screw from each hinge. |
| + | [* black] Remove the bottom screw first. |
| + | [* icon_reminder] During reassembly, first install the hinge screws ***without tightening them fully***. Then adjust the screen until it's correctly centered and aligned on each side. Finally, tighten the screws. |
| + | [* icon_note] If your screen clicks or snaps upon opening, loosen the hinge screws and adjust the alignment. Make sure the screen doesn't sit too far forward, or it'll catch on the body. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0