crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Brent Thompsoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brent Thompson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Heat up the soldering iron to approximately 350 degrees Fahrenheit.
-[* red] Hold the blue and red wires to the circuit board, and the wires should melt right off.
+[* red] Apply the tip of the soldering iron to the connection points, causing the red and blue wires to melt and detach.
[* black] Simply separate the old Rumble Motor from the board and set it aside.
[* icon_caution] Caution: Soldering iron will be hot. Do not touch the tip of the iron.