crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Brendancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brendan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Open the earbud shell
-[* black] Take the thinnest possible tool, and slide it into the gap between the two parts of the earbud's shell.
+[* black] Take the thinnest possible tool, and slide it into the gap between the two parts of the earbud’s shell.
[* red] Then starts lever in the gap between the two parts at the point circled in the picture to begin separating the two parts of the earbud.
- [* icon_note] If the two parts don't separate, you'll need to heat the earbud a little more.
-[* black] One the two parts of the earbud's shell started to separate, continue separate them by lever all around the shell.
- [* icon_caution] Carefull not to burn your fingers as the earbud will be very hot.
- [* icon_note] On the picture I used the iFixit's [link|https://store.ifixit.fr/products/jimmy|new_window=true] opening tool, but I recommend the iFixit's [link|https://store.ifixit.fr/products/iflex-opening-tool|new_window=true] that will be thinner so it will make this step a bit easier.
+ [* icon_note] If the two parts don’t separate, you’ll need to heat the earbud a little more.
+[* black] When the two parts of the earbud’s shell start to separate, continue to separate them by lever all around the shell.
+ [* icon_caution] Careful not to burn your fingers as the earbud will be very hot.
+ [* icon_note] In the picture I used the iFixit’s [link|https://store.ifixit.fr/products/jimmy|new_window=true] opening tool, but I think the iFixit’s [link|https://store.ifixit.fr/products/iflex-opening-tool|new_window=true] is better because it is thinner so it might make this step a bit easier.