crwdns2933803:04crwdne2933803:0
crwdns2933797:0Angelina Jimenezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Angelina Jimenez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] Hot Equipment |
|---|---|
| + | [* black] Once the heater block is cooled down, slightly thread the new nozzle into the heater block. |
| + | [* black] Once the nozzle is inserted, manually set the nozzle pre-heat to ***230C*** and finish threading the new nozzle. |
| + | [* icon_caution] Be careful to not over-tighten the nozzle. Overtightening can also damage the heater block or the nozzle. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0