crwdns2933803:04crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Test the main winding |
|---|---|
| + | [* icon_note] You will need the wiring schematic for your dryer to figure out what terminals are for the run winding. Usually one of those terminals will be shared with the start winding. |
| + | [* icon_caution] Be sure to grip the connector and not the wire when disconnecting. |
| + | [* black] Measure the resistance from the run winding terminal to the common terminal shared with the start winding. |
| + | [* icon_note] This reading should be 2–5 Ω. If it is outside this range the motor is defective and should be replaced. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0