crwdns2933803:04crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Test the main winding |
|---|---|
| + | [* icon_note] This step will require a multimeter. If you aren't familiar with how to use one, [guide|25632|here is a guide|new_window=true] that will help you. |
| + | [* black] Disconnect the top bare copper wire aligned with terminal #5. |
| + | [* icon_caution] Be sure to grip the connector and not the wire when disconnecting. |
| + | [* black] Measure the resistance from the diagonal terminal (between terminals #4–#6) and the top copper wire aligned with terminal #5. |
| + | [* black] This reading should be 3.3–3.6 Ω. If it is outside this range the motor is defective and should be replaced. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0