crwdns2933803:07crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Disconnect the inlet thermistor |
|---|---|
| + | [* icon_note] You can skip this step if your dryer has only a hi limit thermostat. |
| + | [* black] Free the inlet thermistor connector by lifting the locking tab with a small flathead screwdriver or spudger. |
| + | [* icon_caution] The locking tab is fragile, so only lift it a small amount to free the connector. Make sure to grasp the connector, not the wires when removing them. |
| + | [* black] Once freed, pull the connector straight out to disconnect the inlet thermistor. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0