crwdns2933803:07crwdne2933803:0
crwdns2933797:0Philip Le Richecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Le Riche
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Bottom cover | |
| [* red] Remove 4 screws in the cover beneath where the optical sensor was. | |
| [* orange] Remove two screws at the inboard underside ends of the front arms. | |
| [* yellow] Locate two screws retaining the front arms, accessible from deep within the bttery comparment. These have 2.5mm hex heads. Loosen them by a few turns only. You will most likely need a screwdriver extension, or a 2.5mm allen key. Don't remove them. | |
| - | [* black] You should now be able to pull each of the front arms out by a millimetre or so. |
| - | [* black] |
| + | [* black] You should now be able to pull each of the front arms out by a millimetre or so enabling you to remove the cover. |
| + | [* black] Feed the ribbon cable back through the slot in the cover as you remove it. |
| [* icon_note] On reassembly, don't forget to feed the ribbon cable back through the slot. |