crwdns2933803:010crwdne2933803:0
crwdns2933797:0Dan Ccrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dan C
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Lamp driver PCBs |
|---|---|
| + | [* black] The lamp driver PCBs do not have to be removed, but all wires need to be disconnected. Each board has: |
| + | [* red] A 2-pin low voltage connector from the power supply |
| + | [* orange] A small 3-pin connector, on the vertical daughter board |
| + | [* yellow] A 2-pin white connector, carrying high voltage into the lamps. |
| + | [* icon_note] I suggest tucking the white lamp connector back inside the lamp house to keep it out of the way. |
| + | [* black] If removing the PCB, each one is held by 4x T10 screws. |
| + | [* green] The front driver PCB has a plastic insulator on one of its mounting screw posts. Be careful to not lose it! |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0