crwdns2933803:01crwdne2933803:0
crwdns2933797:0Dan Ccrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dan C
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Lamps |
|---|---|
| + | [* icon_note] On the projector's right side are the two lamp doors, and the security lock hole. |
| + | [* icon_caution] Lamps can be removed/replaced while the projector is powered on (it has 2, so the other lamp can continue projection in critical situations). But I suggest doing it with the projector off, and cooled down. |
| + | [* black] Each lamp has a separate door. Unscrew the captive Philips screw at the top of the door and open it. |
| + | [* black] There are 3 plastic thumbscrews per lamp -- two on top and one at bottom. Rotate them 1/4 turn (90 degrees) counter-clockwise to unlock. (Horizontal is locked, vertical is unlocked). |
| + | [* black] Once all 3 screws are unlocked, grasp the lamp housing from the rear protrusion, and pull. If you feel a lot of resistance, try wiggling the screws to ensure they have released. |
| + | [* black] Once the lamp is removed, you can see the three guide pins, which are held by the locking screws. |
| + | [* black] Installation of new lamps is performed in the reverse order. |
| + | [* icon_note] Lamp hours are recorded on a chip in the lamp itself, so there should not be a timer to reset manually. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0