crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Then test to be sure that there is no contact between the two strips. Your meter should read ''***OL***''
+[* black] Use your multimeter to test that there is no contact between the two strips. Your meter should read ''***OL***''
[* black] If the step shows some resistance value between the strips, check for physical contact between the strips.
-[* black] If there is some resistance value, and there is no physical contact between the strips, replace the connector module as shown in the next step
+[* black] If there is some resistance value, and there is no physical contact between the strips, replace the connector module as shown in the next step.