crwdns2933803:03crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] This step will require a multimeter. If you aren't familiar with how to use one, [guide|25632|here is a guide|new_window=true] that will help you. |
|---|---|
| + | [* icon_note] This step and the next one will require a multimeter. If you aren't familiar with how to use one, [guide|25632|here is a guide|new_window=true] that will help you. |
| [* black] Use the multimeter set to resistance (Ω), check to see that there is continuity between each of the two metal strips and their respective sockets on the connector. | |
| - | [* icon_note] You can trace the wire from the back of the strips to the correct point on the connector |
| - | [* icon_note] If either strip shows an open circuit (***''OL''***) to the connector, you can replace the connector module as shown in the next step. If they are both good, skip the next step. |
| + | [* icon_note] You can trace the wire from the back of the strips to the correct point on the connector as shown in the first picture. |
| + | [* black] If the strips show continuity (less than 1 Ω) to the connector, go to the next step. |
| + | [* black] If either strip shows an open circuit (***''OL''***) to its connector, you can replace the connector module as shown in the step after the next one. |