crwdns2933803:07crwdne2933803:0
crwdns2933797:0Elizabeth Eckescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elizabeth Eckes
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing next steps. If current is present, permanent damage to the multimeter is possible! |
|---|---|
| + | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing the next steps. If a current is present, permanent damage to the multimeter is possible! |
| [* black] Connect the black probe to the circuit board rail where one end of the solder bridge was. | |
| [* black] Connect the red probe to the circuit board rail where the other end of the solder bridge was. | |
| [* black] If the fix is successful, the multimeter should give a numerical readout on the multimeter screen. This means the rails are no longer connected. | |
| [* icon_note] If the fix was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit. |