crwdns2933803:06crwdne2933803:0
crwdns2933797:0Stevencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Steven
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Connect red (positive) probe to the Voltage and Resistance Socket. | |
| [* black] Connect black (negative) probe to the Common/Ground Socket. | |
| - | [* black] |
| + | [* black] Set the multimeter knob for continuity testing, typically labeled with diode/audio symbols. |
| [* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly. | |
| - | [* black] Touch the tip of the probes together to verify the multimeter is functioning properly. |
| - | [* icon_note] Upon completing this step above, the multimeter should read a number less than 1. The photo in the guide does not depict this. |
| + | [* black] To ensure the functionality of the multimeter, touch the two probes together and an audible beeping sound should be emitted. |