crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Curt Reitenbachcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Curt Reitenbach

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Set up the multimeter:
- [* black] Connect red (positive) probe to the Voltage and Resistance Socket.
- [* black] Connect black (negative) probe to the Common/Ground Socket.
- [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting.
- [* black] The multimeter will read "OL" if the steps have been followed properly.
- [* black] Touch the tip of the probes together to verify the multimeter is functioning properly.
-[* icon_note] Upon completing the steps above, the multimeter should read a number less than 1. The photo in the guide does not depict this.
+[* black] Connect red (positive) probe to the Voltage and Resistance Socket.
+[* black] Connect black (negative) probe to the Common/Ground Socket.
+[* black] Turn knob of multimeter to the Diode and Capacitance Test Setting.
+ [* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly.
+[* black] Touch the tip of the probes together to verify the multimeter is functioning properly.
+ [* icon_note] Upon completing this step above, the multimeter should read a number less than 1. The photo in the guide does not depict this.