crwdns2933803:06crwdne2933803:0
crwdns2933797:0Curt Reitenbachcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Curt Reitenbach
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Setting up the multimeter: | |
| [* black] Connect red (positive) probe to the Voltage and Resistance Socket. | |
| [* black] Connect black (negative) probe to the Common/Ground Socket. | |
| [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting. | |
| [* black] NOTE: Upon completing the steps above, the multimeter should read "OL" as shown in the picture. | |
| - | [* black] NOTE: Verify the circuit board does not have any current supplied to it prior to performing next step. |
| [* black] Connect black probe to the circuit board where the solder bridge was. | |
| [* black] Connect red probe to the circuit board above where the solder bridge was. |