crwdns2933803:03crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Place the solder wick on top of the solder bridge and heat the wick using the soldering iron by pressing on top of the affected area. |
|---|---|
| + | [title] Remove the solder bridge |
| + | [* black] With the solder wick on top of the solder bridge, heat the wick using the soldering iron by pressing on top of the affected area. |
| [* icon_caution] The solder wick will be very hot! Avoiding touching the area of the wick near the soldering iron. | |
| [* icon_note] Alternatively, use wire cutters to cut off about 2 cm (0.75") of braid. Use [product|IF145-020|tweezers] or needle nose pliers to place it as described above. | |
| [* black] Continue to apply pressure with the soldering iron to the solder bridge until the solder is melted and absorbed by the wick. | |
| [* icon_note] A soldering flux can also be used here to aid in the desoldering process by reducing oxide films. |