crwdns2933803:03crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Test the start winding |
|---|---|
| [* icon_note] This step will require a multimeter. If you aren't familiar with how to use one, [guide|25632|here is a guide|new_window=true] that will help you. | |
| [* black] Disconnect the bare copper wire in line with pin 3 (the lower of the two terminals with bare copper wires on them). | |
| [* black] Check the resistance between the diagonal terminal and the bare copper wire removed from terminal 3 | |
| [* icon_note] The value should be between 2.7 and 3.0 Ω. If it is outside that range or OL the motor is defective and needs to be replaced. The picture shows a good value. |