crwdns2933803:07crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Test the inlet thermistor | |
| - | [* icon_note] If you just need to replace the hi-limit thermostat or inlet thermistor, you can skip this step. |
| + | [* icon_note] This step shows how to test the inlet thermistor. If you just need to replace the hi-limit thermostat or inlet thermistor, you can skip this step. |
| [* yellow] With the thermistor removed from the heater housing, test for resistance with the multimeter across the two small terminals. | |
| - | [* |
| + | [* icon_note] The value shown (61.8 kΩ) is acceptable for a good thermistor at room temperature (68°F/20°C). The nominal range at this temperature is 61.2‑63.7 kΩ. |
| [* black] If the device shows outside this range, replace it. |