crwdns2933803:07crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Test the inlet thermistor |
|---|---|
| + | [* black] With the thermistor removed from the Heater housing, test for resistance with the multimeter across the two small terminals located where you disconnected the thermistor connection two steps ago. |
| + | [* black] The value shown (61.8kΩ) is correct for a good thermistor at room temperature. A variation of 5% from this value is acceptable. |
| + | [* black] If the device shows outside this range, replace it. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0