crwdns2933803:014crwdne2933803:0
crwdns2933797:0Spencer Penningtoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Pennington
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Replace the slider covers |
|---|---|
| + | [* icon_note] The rear case holds [link|https://guide-images.cdn.ifixit.com/igi/WqjknkJGEIVNSxcy.full|two small plastic covers|new_window=true] for the adaptive trigger assembly adjustment sliders. These may have come off during removal. Place them back in the rear cover now to avoid losing them. |
| + | [* black] Use a pair of tweezers or your fingers to lift the cover from the controller. |
| + | [* black] Slide the flat end of the cover under the [link|https://guide-images.cdn.ifixit.com/igi/YFYoA6NpF1ENLYDb.full|plastic tab|new_window=true] in the rear case. |
| + | [* icon_note] Make sure it is placed so it can move freely in its groove. The edge with the notch should be towards the middle of the controller. |
| + | [* icon_note] If a cover got bent during the rear case removal or reassembly process, apply a small amount of heat with a hair dryer to restore it to its original shape. |
| + | [* icon_reminder] During reassembly, you can [link|https://guide-images.cdn.ifixit.com/igi/MdCZ5YBa1bdFZ2j4.full|use a small piece of painter's tape|new_window=true] on the outside of the rear case to hold the covers in place. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0