crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:015crwdne2933803:0

crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_caution] You will encounter many sharp parts in these steps, gloves are highly recommended for these steps.
[* black] Lift the cover off the heater housing. There is a tab on the end of the cover that goes inside the inlet housing pipe.
[* icon_note] Make sure to lift the end of the cover well up so that you can get this tab to come free. Also the tabs on the side of the housing go into slots, and the slots can be sticky.
-[* icon_reminder] When reassembling, make sure all the tabs on the cover have gone all the way through the slots on the sides of the housing and on the heating element. It will snap into place when it is correct.
+[* icon_reminder] During reassembly, make sure all the tabs on the cover have gone all the way through the slots on the sides of the housing and on the heating element. It will snap into place when it is correct.