crwdns2933803:012crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Remove thermal cutoff switch |
|---|---|
| + | [title] Remove the thermal cutoff switch |
| [* red] Use a 1/4 inch nut driver to remove the two 12.8 mm-length sheet metal screws. | |
| [* icon_note] Note the orientation of the part, as there is a tab on the lower part of the heater housing that allows the part to fit properly only one way. The screw tabs are angled slightly to facilitate this. | |
| [* black] Remove the part by lifting it off of the heater housing. |