crwdns2933803:04crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Check the resistance between the top and bottom terminals. | |
| [* icon_note] The multimeter should read about 40 Ω. | |
| [* black] Check resistance from the middle terminal to the heater housing. | |
| [* icon_note] The multimeter should read OL or "—" | |
| - | [* black] If the element has the correct values when tested, you can stop here, you don't have to replace the it. |
| + | [* icon_note] If the element has the correct values when tested, you can stop here. You don't have to replace the heating element. As a precaution, while everything is accessible, you may want to test the components located on the heater housing. |
| + | [* icon_note] For the hi limit thermostat/inlet thermistor combined component follow [guide|160810|this link|stepid=338675|new_window=true] |
| + | [* icon_note] For the thermal cutoff switch follow [guide|160818|this link|stepid=338706|new_window=true]. |