crwdns2933803:03crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the connectors to the system board. | |
| [* red] Place the tip of your opening tool under the edge of the connector, and pry the connector straight up from its socket. | |
| [* orange] Use the tip of a spudger or your fingernail to flip up the small locking flaps from these ZIF connectors. Then, you can safely pull the cables out. | |
| - | [* yellow] Slide a thin, ESD-safe pry tool or tweezers under the wire until it's snug against the connector, and pry straight up from the board to disconnect these coaxial cables. |
| + | [* yellow] Slide a thin, ESD-safe pry tool or [product|IF145-020|tweezers] under the wire until it's snug against the connector, and pry straight up from the board to disconnect these coaxial cables. |
| [* green] To remove the blue connector, pull the cable away from the connector in the same direction that the individual wires are running. | |
| [* icon_caution] Pull evenly on the full width of the cable so that no individual wires are overly strained. | |
| [* light_blue] Lift the final connector up from the socket. |