crwdns2933803:015crwdne2933803:0
crwdns2933797:0Philip Le Richecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Le Riche
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Reassembling the gear chain |
|---|---|
| + | [* icon_note] This is the bit you thought would be nearly impossible, but it's not actually very hard. |
| + | [* black] With the front plate flat on the table, insert all the gears ito their pivot holes in the reverse order to that in which you removed them. |
| + | [* black] You will probably find the main spring winder is taller than any of the pivots. Lower the back plate onto this and onto the four posts joining the frant and back plates. |
| + | [* black] At this stage, none of the pivots will be lined up with its pivot hole, but one may be taller than the others. Gently manoevre this into its pivot hole. |
| + | [* black] Repeat for each pivot in turn. If two are pretty much the same hight, angle the back plate by only sufficient to get them in one at a time. |
| + | [* black] Once all the pivots are in their pivot holes (double chack that they indeed are) you should beable to press down the back plate onto the four pillars as far as it will go. You can now reinsert the locking pins. |