crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Unfasten front panel
-[* red] Use a 1/4 inch hex driver to unfasten the three upper front panel 16.4 mm-long screws.
+[* red] Use a 1/4 inch nut driver to unfasten the three upper front panel 16.4 mm-long sheet metal screws.
[* black] Tilt the machine to the rear and either prop it securely, or have a friend hold it securely
-[* orange] Use a 1/4 inch hex driver to remove the six screws on the bottom edge of the panel. The lengths in order from left to right will be 13 mm, 16.4 mm, 13 mm, 13 mm, 16.4 mm, 13 mm.
+[* orange] Use a 1/4 inch nut driver to remove the six sheet metal screws on the bottom edge of the panel. The lengths in order from left to right will be 13 mm, 16.4 mm, 13 mm, 13 mm, 16.4 mm, 13 mm.