crwdns2933803:02crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unfasten front panel | |
| - | [* red] Use a 1/4 inch hex driver to unfasten the three upper front panel |
| + | [* red] Use a 1/4 inch hex driver to unfasten the three upper front panel 16.4 mm-long screws. |
| [* black] Tilt the machine to the rear and either prop it securely, or have a friend hold it securely | |
| - | [* orange] Use a 1/4 inch hex driver to remove the six screws on the bottom edge of the panel. |
| - | [* icon_note] The lengths of these screws will vary, so note the length and location as each one is removed. |
| + | [* orange] Use a 1/4 inch hex driver to remove the six screws on the bottom edge of the panel. The lengths in order from left to right will be 13 mm, 16.4 mm, 13 mm, 13 mm, 16.4 mm, 13 mm. |