crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Unfasten the XX.X mm-length, 1/4 inch hex drive screw holding the Cycle Control Unit (CCU) bracket to the chassis.
-[* icon_note] If the CCU bracket has already been unfastened from the front of the machine you can drape it over the side of the machine after you unfasten it.
-[* orange] Unfasten the two XX.X mm-long 1/4 inch hex-drive screws from the top rear of the machine.
+[* red] Unfasten the 16.4 mm-length, 1/4 inch hex drive screw holding the Cycle Control Unit (CCU) bracket to the chassis.
+[* icon_note] If the CCU bracket has already been unfastened from the front of the machine you can drape it over the side of the machine after you unfasten it if necessary.
+[* orange] Unfasten 1/4 inch hex-drive to remove the two 20 mm-long screws from the top rear of the machine.