crwdns2933803:04crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Unfasten the XX.X mm-length, 1/4 inch hex drive screw holding the Cycle Control Unit (CCU) bracket to the chassis. | |
| - | [* icon_note] If the CCU bracket has already been unfastened from the front of the machine you can drape it over the side of the machine |
| + | [* icon_note] If the CCU bracket has already been unfastened from the front of the machine you can drape it over the side of the machine after you unfasten it. |
| [* orange] Unfasten the two XX.X mm-long 1/4 inch hex-drive screws from the top rear of the machine. |