crwdns2933803:01crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the rear panel |
|---|---|
| + | [* red] Use a 5/16 inch hex driver to remove the green ground screw. |
| + | [* orange] Use a Phillips driver to remove the two XX.X mm-long cord terminal block screws. |
| + | [* yellow] Use a 1/4 inch hex driver to remove the eleven (11) rear panel screws. |
| + | [* icon_note] The rear panel screws will be of varied length, you should note their location carefully as you go. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0