crwdns2933803:014crwdne2933803:0
crwdns2933797:0Andrej Walilkocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrej Walilko
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Attach The Top |
|---|---|
| + | [* light_blue] Attach the four motor and sensor wires coming from the unit lid to the motherboard. |
| + | [* black] Fold the top down over the vacuum and snap it into place. |
| + | [* icon_caution] This step should not require many pounds of force. If something does not connect together properly, remove the top again and check that all of your previous steps were successful. I find that most difficulty was related to correctly seating the wheel wells and routing the wires to the top of the motherboard under the plastic tab on the right wheel. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0