crwdns2933803:08crwdne2933803:0
crwdns2933797:0Andrej Walilkocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrej Walilko
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Installing The Right Wheel Well (cont.) | |
| - | [* green] While installing the housing into the unit, ensure that each of the three wire bundles coming out of the top of the motherboard by the power switch are placed underneath this plastic tab. This tap keeps them from being pinched when the top cover is replaced. |
| + | [* green] While installing the right wheel housing into the unit, ensure that each of the three wire bundles coming out of the top of the motherboard by the power switch are placed underneath this plastic tab. This tap keeps them from being pinched when the top cover is replaced. |
| [* icon_note] If the vacuum suction motor or the water pump motors were removed before this step, ensure that their wires are inserted under this tab now, before finishing the wheel well installation. | |
| [* light_blue] Replace the sensor wires which were temporarily placed outside of the screw pegs. | |
| [* icon_caution] Both of the wheel wells should be at the same height above the top of the dust bin area. If they are not equal, it is possible that one of the housings has a pinched wire, or was incorrectly stressed upon insertion, meaning that it did not fully seat down along the sides. | |
| [* icon_note] Give the sides of the wheel well a quick pinch to see if this correctly seats the wheel well. Snug up all screws again if you find success. |