crwdns2933803:014crwdne2933803:0
crwdns2933797:0Andrej Walilkocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrej Walilko
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the wheel wells and springs |
|---|---|
| + | [* icon_note] This section is required to repair the wheel motors or beater bar motor. It can (and should) be skipped in most other repairs. |
| + | [* light_blue] Remove the 4 silver 10mm screws on each wheel well. |
| + | [* icon_caution] Many wires are routed around the sides and top of these wheel wells. Take care not to pull or damage these wires when uninstalling the wheel wells. |
| + | [* icon_note] The wheel wells have the traction springs inside of them, so you will hear a snap as you remove the final screws. |
| + | [* red] Do not errantly remove or adjust the black spring retention screw. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0