crwdns2933805:0crwdne2933805:0
crwdns2933797:0Patricia Reynoldscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Patricia Reynolds
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Put the new motor into place where the old motor was and screw it into place. This is to ensure fit. |
|---|---|
| + | [* orange] Put the motor and plate into the place where the components are normally at and put cover for the components over the mot0r and plate. I replaced the 4 screws for the cover to not lose them. |
| + | [* yellow] The gear attached to the motor can be seen inside the open arch and the cover will be able to close without a problem. Once verified to fit, remove motor. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0