crwdns2933803:07crwdne2933803:0
crwdns2933797:0Harsh Mishracrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Harsh Mishra
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] You need to use a plier to rip all 4 of the battery contact tabs (two contact tabs attached to the batteries on each end), and lift the batteries out of the battery holder. | |
| - | [* icon_caution] ***Caution! The temperature of the soldering iron is 450 degrees Fahrenheit. Do not apply melted soldering |
| + | [* icon_caution] ***Caution! The temperature of the soldering iron is 450 degrees Fahrenheit. Do not apply melted soldering alloy for more than 15-20 seconds of time intervals. *** |
| [* icon_caution] ***Do not touch the tip of the Soldering iron directly onto the battery. Only apply melted solder alloy onto the battery contact tab.*** | |
| [* black] You need to apply Soldering paste on the battery contact tab and then melt solder alloy on to the tip of the soldering iron and touch the tip of the soldering iron to one of the 4 specified battery contact tab. Repeat this step for the other 3 battery contact tabs. | |
| [* black] Now place the new batteries on the battery holder attaching them to the soldered battery contact tabs. Apply some more soldering iron alloy if the batteries do not feel rigid on the holder. | |
| [* icon_reminder] ***Ensure that the positive and negative electrodes are correctly identified when you place the new batteries onto the holder.*** |