crwdns2933803:06crwdne2933803:0
crwdns2933797:0knipwimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 knipwim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] press the axle back |
|---|---|
| + | [* icon_note] When pressing in the axle, ensure that the bearings are not pressed out again by supporting the bearings. |
| + | [* icon_note] Use a spacer that can hold in the bearing, but allow the axle to be pressed through. |
| + | [* icon_note] You can 3D print such a spacer, or use the outer ring of the replaced bearing (ground down to prevent press fit). |
| + | [* red] Place the spacer. |
| + | [* orange] Let the spacer push on something, a large socket for instance, and center it on the press. |
| + | [* yellow] Press in the axle until the retaining ring groove is above the bearing (and the retaining ring can be put back). |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0