crwdns2933803:012crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Soften the top edge adhesive | |
| [* black] Apply a [guide|25705|heated iOpener|new_window=true] to the top edge of the screen for two minutes. | |
| [* icon_note] Alternatively, use a [guide|151116|heat gun|new_window=true] or [guide|157348|hair dryer|new_window=true] to soften the adhesive. Be careful not to overheat the top edge sensors—this region doesn't need as much heat. | |
| - | [* icon_note] While you wait for the adhesive to soften, note the following areas: |
| + | [* icon_note] While you wait for the adhesive to soften, make note of the following areas: |
| [* red] The left section of adhesive extends ***69 mm ***(2.7 in) from the left edge of the screen and is ***6 mm deep***. | |
| [* orange] The middle section of adhesive is ***2 mm deep***. The sensors are held in a protective bracket adhered to the screen. | |
| [* yellow] The right section of adhesive extends ***84 mm*** (3.3 in) from the right edge of the screen and is ***6 mm deep***. |