crwdns2933803:012crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Soften the top edge adhesive | |
| [* black] Apply a [guide|25705|heated iOpener|new_window=true] to the top edge of the screen for 2 minutes. | |
| [* icon_note] You can also use a heat gun or hair dryer to heat the screen. Be careful not to overheat the top edge sensors. | |
| [* icon_note] While you wait for the adhesive to soften, note the following: | |
| [* red] The left section of adhesive reaches 69 mm (2.7 in) from the left edge of the screen. It's 3 mm deep, with a thin strip 6 mm deep on the magnet. | |
| - | [* orange] The middle section of adhesive is 2 mm deep. |
| + | [* orange] The middle section of adhesive is 2 mm deep. The sensors are held in a protective bracket. |
| [* yellow] The right section of adhesive reaches 84 mm (3.3 in) from the right edge of the screen. It's also 3 mm deep, with a thin strip 6 mm deep on the magnet. |