crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Maribella Riveracrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Maribella Rivera

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] With the interchangeable screwdriver, insert the J1 Phillips head bit into the screwdriver handle.
-[* red] Remove the three screws at the top(three millimeter), two on either side(three millimeter), and three at the bottom with the screwdriver (three millimeter).
+[* red] Remove the six, three millimeter screws.
[* black] Place screws in the order removed on the magnetic mat.
[* icon_note] Make sure to keep up with your screws, they are small and not all the same.