crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Sebastiancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sebastian

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Apply a load between L and PE
[* violet] Use the load feature of the Duspol to apply a load between L and PE.
- [* icon_reminder] This will not trigger a RCD with a rated residual current higher than 30 mA, though you shouldn't have a RCD rated over 30 mA installed in your home since that's the maximum permissible rated residual current for personal protection anyways.
+ [* icon_reminder] This will not trigger an RCD with a rated residual current higher than 30 mA, though you shouldn't have an RCD rated over 30 mA installed in your home, as that's the maximum permissible rated residual current for personal protection anyways.
[* icon_note] If your Duspol does not have the load feature or if you do not have a Duspol, you can still test the GFCI by shorting the ***neutral ***to ground. However, to do this, it is important to ensure that a device is currently drawing power from the circuit being tested. This is typically the case in most household settings.