crwdns2933803:024crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unfasten the logic board | |
| [* black] Use your T5 Torx driver to remove the ten screws securing the logic board to the frame: | |
| [* red] Six 3.8 mm screws surrounding the fans | |
| [* orange] Four 4.6 mm screws along the bottom edge | |
| [* yellow] Use a 4 mm hex driver to remove the two 6 mm bolts securing the bottom corners of the logic board to the frame. | |
| - | [* icon_reminder] During reassembly, first thread these bolts in with your fingers or blunt nose tweezers |
| + | [* icon_reminder] During reassembly, first thread these bolts in with your fingers or blunt nose tweezers, then tighten them with your driver. |
| [* green] Use a T6 Torx driver to remove the two 6 mm screws securing the heatsink and logic board to the frame. |