crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0shivan mahadeocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 shivan mahadeo

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Set the new taillight in the groove until you get a snug fit, and the rubber grommet (in the screw hole) has a watertight seal. (This is very important to keep rainwater out of the taillight.)
+[* red] Set the new taillight in the groove until you get a snug fit, and the rubber grommet (in the screw hole) has a watertight seal. (This is very important to keep rainwater out of the taillight.)
[* icon_caution] Do not over torque the screws as the black rubber gasket surrounding the taillight will come through the hole resulting in a non-water-tight seal. Hand-tight torque is all that is needed.