crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] once the speaker that is housed in the backplate is unconnected to the motherboard position it upside down
-[* black] When positioned properly plug in the heat gun. Aim the gun from a distance to prevent any damage to the plastic. Then began heating the adhesive.
-[* black] The gun should be shut off once either the smell of the adhesive is fragrant or the glue around the rim looks melted.
-[* black] Then proceed to push in the speaker to remove it. this should be done safely with tweezers to avoid burns
+[* black] Position the speaker so the inside is facing up.
+[* black] Use a [guide|151116|heat gun|new_window=true] to warm the adhesive securing the speaker to the housing. Then began heating the adhesive.
+[* icon_caution] Aim the gun from a distance to prevent any damage to the plastic. Always keep the heat gun in motion while using it so one area doesn't melt.
+[* icon_caution] Use tweezers to push the speaker through to remove it. Avoid using your hands directly on the speaker to avoid burns.