crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Insert one arm of your angled tweezers under the right speaker antenna connector, as close to the connector head as possible.
-[* black] Gently lift straight up to disconnect the cable.
- [* icon_caution] Be careful not to tear the socket from the logic board as you disconnect the cable.
-[* icon_reminder] To reattach antenna connectors like these, align the connector over its socket and press down with the flat end of a spudger. The connector should snap into place.
+[* black] Use a pair of tweezers to grip the right antenna connector, as close to its base as possible.
+[* black] Lift straight up to disconnect the cable.
+ [* icon_caution] The antenna connectors on the logic board are very fragile. When disconnecting the cables, pull straight up—don’t bend them to the side.
+[* icon_reminder] To reattach [guide|25629|antenna connectors|stepid=64972|new_window=true] like these, align the connector over its socket and press down with the flat end of a spudger. The connector should snap into place. This can be tricky and may take a few tries.