crwdns2933803:09crwdne2933803:0
crwdns2933797:0PedroDaGr8crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 PedroDaGr8
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the hall effect sensor and powertrain/motor |
|---|---|
| + | [* black] Remove the hall effect sensor from its mount by pressing down on the tab indicated in the first image and sliding it out. |
| + | [* black] Now that it is fully disconnected from the mixer, remove the old powertrain/motor and place it to the side. |
| + | [* black] Take care to protect the motor/powertrain, especially the plastic fan at the rear, as damage to any part of the motor/powertrain (including said fan) will require replacement of the entire unit. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0